Norman Dunn's 'Hebburn and our Neighbours Forum' : Re: An addendum to the above but about Boats built by 3D printing of hull

Norman Dunn's 'Hebburn and our Neighbours Forum'
[ Post a Response | Norman Dunn's 'Hebburn and our Neighbours Forum' ]

Rules! No Bad language or derogatory remarks Please or we will delete. Anyone sharing our content on Face Book must credit 'Hebburn and our Neighbours'.

Re: An addendum to the above but about Boats built by 3D printing of hull

Posted by Malcolm on 1/12/2025, 10:33 pm, in reply to "Re: An addendum to the above but about Boats built by 3D printing of hull "

Stan, when I was in engineering, we were using water jet cut titanium & Inco 625 (similarly hard metal) back in the late 1990's early 2000's

Super fast & accurate; we used the parts to make the exhausts for the Boeing 737 fleet & Airbus A320's.

When us lads were young a lot of us would have built model planes - Allan C. 29/11/2025, 7:36 am

Re: When us lads were young a lot of us would have built model planes - Stan Wears 29/11/2025, 5:03 pm
- Stan - Allan C 29/11/2025, 8:02 pm
An addendum to the above but about Boats built by 3D printing of hull - Allan C. 1/12/2025, 1:29 pm
- Re: An addendum to the above but about Boats built by 3D printing of hull - Stan Wears 1/12/2025, 5:35 pm
  - Re: An addendum to the above but about Boats built by 3D printing of hull - Malcolm 1/12/2025, 10:33 pm

« Back to index | View thread »

Post a Response

Rules! No bad language or derogatory remarks or we will delete. Anyone sharing our content on Face Book must credit 'Hebburn and our Neighbours'.