I am nearing defeat on this effing pressure washer "rebuild." Archived Message Posted by longsnapper on May 16, 2025, 11:41:42 Ryobi 2300psi/1.2gpm electric. I wasn't getting pressure, so I cleaned out the pump with some CLR. The only disassembly I did was removing the inlet hose and outlet high pressure hose. Then I saw these three pieces on the ground, and can not find any information on them or where they go. I know the spring meats inside the white cage and has to be a pump valve of some sort. The cat has been less than helpful. Any body have an idea? I really don't want to scrub my fucking deck by hand. Message Thread: I am nearing defeat on this effing pressure washer "rebuild." - longsnapper May 16, 2025, 11:41:42 Since I know you're all waiting on pins & needles, I figured it out... - longsnapper May 19, 2025, 15:35:03 After issues with my last electric pressure washer it recently found itself in a dumpster. - EffinIllini May 16, 2025, 12:00:11 looks like a check valve assembly - IlliniSax05 May 16, 2025, 11:55:45 Agreed, it looks like a check valve spring, maybe a plug that holds the assembly in place (?), - IlliniOllie May 16, 2025, 12:01:31 I was thinking it would go at the inlet to the high pressure hose - IlliniSax05 May 16, 2025, 12:09:53 That's what I think/thought, but there's nothing to house it. And it doesn't - longsnapper May 16, 2025, 12:32:46 If you can't get it working, buy a new one. They're great and like $100 at costco.* - Warrin'_Illini May 16, 2025, 11:44:06 I was actually planning on buying a new one anyway, so I could keep one on the roof - longsnapper May 16, 2025, 11:46:51 Re: I was actually planning on buying a new one anyway, so I could keep one on the roof - deadpoolOG10 May 16, 2025, 12:41:42   Searching